12-22-2025 – TBT - Slip, Trip, and Falls

Slips, trips, and falls are one of the leading causes of injuries and fatalities in the workplace. According to OSHA, slip, trip, and fall incidents cause 15% of all accidental deaths and are second only to motor vehicle incidents as a cause of fatalities on the job. These types of incidents can result in life-changing injuries to the employees who suffer them.

Common Slip, Trip, and Fall Incidents:

• Falls from elevation are often deadly or result in serious injury and may include falls from ladders, falls off mobile equipment, falls from roofs or other elevated structures, etc.
• Slip incidents on slippery surfaces such as snow and ice are common in colder geographical areas in the U.S. Wet floor conditions or spilled liquids are also common causes of slip incidents at work.
• Trips can be caused by a multitude of reasons, including poor housekeeping, changes in elevation, poor lighting conditions, improper footwear, etc.

Mitigation Actions to Prevent Slip, Trip, and Fall Incidents:

• Always use fall prevention or protection for work over 4ft in general industry work and 6ft in the construction industry. Protect workers by using proper guarding of any holes or open windows and use guardrails to prevent falls. Where guardrails are not feasible, use adequate fall protection.  An example of adequate fall protection is a full-body harness and a self-retracting lanyard attached to an approved anchor point with 100% tie-off.
• Proper housekeeping is very important in preventing slip, trip, and falls incidents. Objects on the ground create a hazard for anyone walking or working in the area. Maintain clearly defined paths for walking in the work area. Maintain organized areas for tools and equipment out of the way of employee foot traffic.
• Address any wet, slippery, or icy walking surfaces in your work area. Post signs of any hazardous surfaces until the situation is taken care of completely.
• When climbing up or down a portable or fixed ladder, ensure that you use proper techniques, such as using three points of contact and keeping your belt buckle within the sides of the ladder. Do not lean to reach objects- this can throw off your balance, and you could fall.

By Clicking "Mark as Read" - you are acknowledging you have read this entire (opened appropriate attachments) ToolBox Talk and understand this is company policy and will abide by regulations outlined in this safety policy. Please complete your acknowledgement within 24 hours of release. If you are receiving this notice, you are REQUIRED to read this content.